RC-S2LP-XXX-EK-HA

The RC-S2LP-XXX-EK-HA board is based on RC-S2LP-XXX-HA RadioControlli’s module. This module is based on STMicroelectronics chip (S2-LP) that is a sub-1 GHz ultra-low power low data-rate transceiver, suitable for ISM bands and Wireless M-Bus.

The Evaluation board can be used instead of those provided by the chip manufacter (www.st.com) denominated STEVAL-FKIXXXV2. With this board it is possible to use all the SW resources provided for the development activity, in particular :

- STSW-S2LP-DK ----> S2-LP-DK Application Notes

- STSW-S2LP-SFX-DK ----->S2-LP SigFox Demo

Datasheet

Development Kit with STEVAL-FKI868V1

Development Kit with RC-S2LP-868-EK

The RC-S2LP-XXX-EK evaluation boards are designed to work in the sub 1GHz band (433/868/915 versions).
Some features on the boards are (see the picture belowe) :
• RC-S2LP-XXX.HA module (A)
• Two rows with Arduino compliant connectors (D1-4)
• UFL connector (B)
• A NUCLEO-L152RE or NUCLEO-L053R8 evaluation board (G)
• A jumper for RC-S2LP-XXX current measurement (H)

RC-S2LP-XXX signal test points are split across two rows which are Arduino compliant connectors: CN1, CN2 and Cn3, CN4. The RC-S2LP-XXX shield is connected to the Nucleo motherboard via the Arduino compliant connectors.

ARDUINO Connector

RadioControlli Module

Pin	Name	CN1(D1)	CN1(D2)	CN1(D3)	CN1(D4)
1	SDO	Pin 5 (MISO)
2	SDI	Pin 4 (MOSI)
3	SCLK		Pin 4(SCLK)
4	CSn				Pin 2(CS)
5	GPIO-0				Pin 1(GPIO-0)
6	GPIO-1				Pin 3(GPIO-1)
7	GPIO-2				Pin 4 (GPIO-2)
8	GPIO-3				Pin 6 (GPIO-3)
9	GND	Pin 7		Pin 6,7
10	SDN		Pin 8 (SDN)
11	GND	Pin 7		Pin 6,7
12	GND	Pin 7		Pin 6,7
13	VCC			Pin 4
14	VCC			Pin 4
15	GND	Pin 7		Pin 6,7
16	GND	Pin 7		Pin 6,7
17	GND	Pin 7		Pin 6,7
18	GND	Pin 7		Pin 6,7

Information Request:

Download RadioControlli

Catalog

Link to Buy Samples

RC-S2LP-868-EK-HA

Link to Buy Samples

RC-S2LP-915-EK-HA

Would you be interested in :

Create Website with flazio.com | Free and Easy Website Builder